![](https://downloads.ecoforest.com/wp-content/uploads/2022/11/ecosmart_esource_ok.png)
ecoSMART e-source
ecoSMART Supervisor
Characteristics:
Compatible with ecoGEO+ HP heat pumps.
Cascade system: up to 6 units of ecoGEO+ HP.
Optimal performance: modulation of power in the different units in order to obtain the maximum performance...
ecoSMART Supervisor
Characteristics:
- Compatible with ecoGEO+ HP heat pumps.
- Cascade system: up to 6 units of ecoGEO+ HP.
- Optimal performance: modulation of power in the different units in order to obtain the maximum performance of heat pumps.
- Balanced distribution of operating hours: equal distribution of the operating hours of each unit throughout the cascade, making sure too much pressure is not put on a single unit.
- This controller must be connected to the pLAN network of the cascading system.
![](https://downloads.ecoforest.com/wp-content/uploads/2022/11/ecosmart_esource_ok.png)
ecoSMART e-source
Characteristics:
- Compatible with ecoGEO+ heat pumps.
- Required in hybrid installations: up to 4 different collection sources.
- Defrost management: ecoGEO+ defrosting system with compressor switched off, and without the need for an inverting the cycle. Independent defrosting protocol in the aerothermal units, so that the system can continue to provide service even during the defrosting process of an aerothermal unit.
- Optimal performance: source management allowing for optimal performance in the installation.
- This controller must be connected via pLAN to the heat pump or heat pumps integrating the cascade.
![](https://downloads.ecoforest.com/wp-content/uploads/2022/11/ecosmart_esource_ok.png)
ecoSMART e-source community
Characteristics:
- Compatible with ecoGEO+heat pumps.
- Required for common source system.
- Hybrid installations: management of up to 3 different sources.
- Defrost management: ecoGEO+ compressor stopped and no need to reverse the cycle. Defrost protocol independent of the air source units, so that the system can continue to operate even during the defrosting process of the air source unit
- Optimal performance: source management logic to achieve optimal system performance
![](https://downloads.ecoforest.com/wp-content/uploads/2023/06/ecoSMART_esource_community.jpg)
ecoSMART easynet
Characteristics:
- Compatible with ecoGEO+ and ecoAIR+ heat pumps.
- Remote control: Internet access to the heat pump control.
- Configuration management: access and management of parameters and equipment configuration.
- Instant acccess to data:
- Access to instantaneous functioning data: real time visualisation of the operating parameters and equipment performance.
![](https://downloads.ecoforest.com/wp-content/uploads/2023/06/easynet.jpg)
Click on the drop-down menu to show files in French, German, Dutch and Italian
Technical manuals (1)
This section is only for registered users. Register
Technical datasheets (1)
Software (15)
This section is only for registered users. Register
Technical service (2)
This section is only for registered users. Register
Procedures (1)
This section is only for registered users. Register